KEY POINT 1 OF 4Paragraph 2
Transnet Freight Rail ran a 4.7-mile train of 696 empty ore wagons on the Sishen-Saldanha Bay iron ore line in South Africa on October 18.
KEY POINT 2 OF 4Paragraph 9
Transnet spread the electric and diesel locomotives across the length of the train, with a radio link keeping them synchronized for traction and braking.
KEY POINT 3 OF 4Paragraph 11
Class 15E electric and Class 43D diesel-electric locomotives shared the work, while the 696 CR13/14 ore wagons ran empty.
BHP’s 682-car train in Western Australia, 4.57 miles long, still holds the Guinness record and weighed around 220 million pounds loaded.
Ask the box:
Depending on where you are in the world, a typical freight train runs between a half-mile and a mile and a half, according to the Associated Press. That’s already a lot of trains to cross at a level crossing. South Africa’s state-owned freight railway has apparently decided that this is not enough.
On October 18, Transnet Freight Rail finished running a 4.7-mile train of 696 empty ore wagons on the country’s iron ore export line, which connects the Sishen mine in the Northern Cape to the Saldanha Bay port on the west coast. The trip took two days and covered approximately 535 miles. Transnet claims this is a new world record for freight train length.
Guinness hasn’t signed it yet. A month later, its own registration page still lists the previous holder, and we’ll see who it is.
You’ll see Transnet call them railcars, while most Americans would say ore cars or boxcars. It’s the same thing with a different accent.
So how do you stop a 4.7 mile long train?
It turns out that you do it very carefully, and mainly on the radio.
On a conventional freight train, the locomotives sit at the front and drag everything behind them. This means that the coupler located just behind the last locomotive pulls all the cars on the train, while the coupler on the last car only pulls one. Braking has its own problem. Most freight cars use air brakes actuated by pressure in a pipe that runs the length of the train, and when the engineer lowers that pressure, the change travels through the pipe like a wave. So the cars at the back start to brake a little after the cars at the front. Railroad workers call the shoving and pulling that follows slow action, and it’s basically the train bumping into itself.
Now suppose you have hooked up all 696 cars behind a block of locomotives at the head of the line. The first couplers would support the traction of a train more than four and a half miles long. And every time the engineer braked, miles of rolling steel behind continued to advance on cars that had already started to slow down.
This seems like a pretty reliable way to break something expensive.
The locomotives take their orders by radio
The railroad’s solution is a setup it calls Radio Distributed Power. Instead of grouping each locomotive together at the front, the railroad spread the electric and diesel locomotives across the length of the train, and a radio link allows them to operate as a single synchronized unit. When the lead locomotive pulls or brakes, those following the train do the same thing at the same time. So the train receives several smaller pulls spread across its length instead of one huge pull from the front, and the braking force is shared equally.
According to Transnet’s statement, this is how it manages longitudinal forces on a train of this size, meaning the push and pull that extends from front to back. The railroad credits the system with more stable handling and less stress on cars and track.
Power came from Class 15E electric locomotives operating alongside Class 43D diesel-electric locomotives. It’s a bit of an odd pairing if you’re used to American freight railroads, which run on diesel-electric power in almost all areas. However, I couldn’t find any locomotive counts anywhere in the release, and it doesn’t say how many of each class went where. Which is a little frustrating to leave out an announcement that only concerns where you place your locomotives.
The wagons were CR13/14 ore wagons from the railway. All 696 of them ran empty and I haven’t seen a published weight for the train.
Transnet first ran the train on a computer
Before anything moved, the railroad’s train design specialists modeled the dynamics of the train, where each locomotive should sit, whether the route was ready, how the train should be driven and how the radios would communicate with each other. Some of these specialists then came to see how reality behaved. Transnet says it will compare locomotive data from the route with simulations to see if its models held up. Transnet Engineering, the company’s rail infrastructure manager and the country’s rail safety regulator were also involved. In my opinion, this comparison is probably more valid for the railway than the balance sheet itself.
So why run it empty?
The railroad didn’t really explain this part. It is a train evaluation program with two goals: chasing the record and learning more about train design, operation and performance. Russell Baatjies, chief executive of Transnet Freight Rail, said “the real value is in the technical knowledge” produced by the exercise.
It’s probably safe to assume that an empty train is the gentlest way to learn how 4.7 miles of cars handle, since there’s much less weight inside. The vacuum also corresponds to the direction of movement. Saldanha Bay is the export port, so cars heading inland towards the mine would normally be empty anyway.
Old record belongs to Australian ore train
The train that Transnet is trying to take first place belongs to BHP. On June 21, 2001, the miner drove 682 loaded ore wagons through the Pilbara region of Western Australia with eight diesel-electric locomotives, and Guinness World Records lists this train as being 4.57 miles long. We covered this journey and the distributed energy that made it possible in our article on Australia’s driverless mineral trains.
Transnet’s train has 14 more carriages than BHP’s, 696 versus 682, and travels 4.7 miles versus 4.57 miles. That puts it between 700 and 800 feet taller, depending on how you round.
Cars
696 against 682
Transnet’s empty test train versus BHP’s record loaded train.
Length
4.7 vs. 4.57 miles
Transnet figure compared to Guinness length for BHP train.
Locomotives
Not given against 8
Electric and diesel-electric units on Transnet train; eight diesel-electrics on the BHP.
ON HOLD
Guinness Status
Unconfirmed
Transnet’s claim has not been certified; Guinness still lists BHP.
The BHP train still gains a mile in weight. Loaded with ore, it weighed approximately 220 million pounds, or just under 110,000 short tons, also making it the heaviest freight train ever recorded by Guinness. As far as I know, Transnet isn’t going after that one.
There is also a bit of history on the South African side. Transnet held the title for the longest train on this same line before BHP won it, which is why South African media are portraying this route as the railway that took it back.
So the claim is still awaiting paperwork. The International Railway Journal noted that independent certification has not been confirmed and that as of November 21, the Guinness page for longest freight train still lists BHP’s 682-car train as the record holder.
You have read 0 of the 4 key points5 min · 1,137 words
A 2,535-ton German drilling machine located 2,300 feet beneath the French Alps spent months digging through about 200 feet of coal, water and mud, then hit up to five concrete rings a day, or about 33 feet of tunnel, before parking itself for scheduled maintenance until the new year.Industry · 3 days ago
A 400-ton generator installed in a South Dakota dam has been dismantled for the first time in 70 years, its 275-ton rotor lifted by two cranes working at the same time, and the first new turbine wheel has now entered the power plant to bring each unit up to 52 megawatts.Energy · 3 days ago
A 13,500-ton U.S. icebreaker that celebrated 50 years in the Antarctic towed a 4,200-ton pier made of frozen seawater out of a McMurdo Bay, cut a 7-mile channel through ice up to 8 feet thick, escorted a 600-foot oil tanker, freed a cruise ship in six hours and is already preparing to depart.Industry · 3 days agoGn world
